The Total Security Alarm System has a total of 99 Zones, each of which can be programmed with different Attributes. These Attributes will determine the behavior of any and all sensors in that Zone.
- Zone Attribute Summary
- Pre-Programmed Settings
- Best Practices / Recommendations
- Instructions For Changing Attributes
Zone Attribute Summary
Note that the Total Security system can be armed in two modes, the "Armed" mode, and the "Stay" mode.
|1 - Instant||
|2 - Home||
Sensors are active when armed in Armed mode,
and inactive when in armed in Stay mode, or when Disarmed.
|3 - Smart||
This Attribute requires a sensor to be triggered 2 times within 3 seconds before setting off the alarm. This is a great feature for helping to prevent false alarms.
|4 - Emergency||
Sensors are active when armed in Armed or Stay mode, and also when Disarmed.
|5 - Disable||
Sensors are inactive in any state (Armed, Stay, or Disarmed).
|6 - Doorbell||
Plays a doorbell sound when sensor is triggered in any state (Armed, Stay, or Disarmed). In this way, you can use a Panic Button as an actual doorbell.
|7 - Chime||
Produces a chime sound when armed in Stay mode.
|8 - Medical||
Here is an example of how a Total Security F Kit would be pre-programmed (your kit may differ):
|Device||Zone Number||Zone Attribute|
|Motion Detector 1||01||2 - Home|
|Motion Detector 2||02||2 - Home|
|Motion Detector 3||03||2 - Home|
|Motion Detector 4||04||2 - Home|
|Door/Window Sensor 1||05||1 - Immediate|
|Door/Window Sensor 2||06||1 - Immediate|
|Door/Window Sensor 3||07||1 - Immediate|
|Door/Window Sensor 4||08||1 - Immediate|
|Door/Window Sensor 5||09||1 - Immediate|
|Door/Window Sensor 6||10||1 - Immediate|
|Door/Window Sensor 7||11||1 - Immediate|
|Door/Window Sensor 8||12||1 - Immediate|
|Door/Window Sensor 9||13||1 - Immediate|
|Door/Window Sensor 10||14||1 - Immediate|
|Smoke Detector||15||4 - Emergency|
|Glass Break Sensor||16||1 - Immediate|
|Panic Button||99||4 - Emergency|
The remote control key fobs also get programmed to the system, in separate 'Remote Control Zones', or 'RC Zones'.
|Remote Key Fob 1||1|
|Remote Key Fob 2||2|
|Remote Key Fob 3||3|
|Remote Key Fob 4||4|
Best Practices / Recommendations
We recommend placing Motion Detectors into a Zone with Zone Attribute 2 - "Home". This way, they will be active when you're out of the house and the system is armed in Out mode, but they will be inactive when you're at home, and the system is either armed in Home mode, or disarmed altogether.
We recommend placing Door/Window Contact Sensors into a Zone with Zone Attribute 1 - "Immediate".
We recommend placing any Panic Buttons, Smoke Alarms, Gas Leak Detectors, or Water Level Sensors into a Zone with Zone Attribute 4 - "Emergency".
Instructions For Changing Attributes
To change a Zone's Attribute, navigate to the Zone settings directly by following the steps below:
- On the Main Panel, enter your Administrator password, then press the Menu button [three horizontal lines].
- Navigate to "Sensors", then select "Sensor".
- Scroll to the desired Zone, and press OK.
- Scroll down to Attribute.
- Select the desired Attribute by entering the desired Attribute number.
- Press OK to save your changes.
- Press the Back button to return to the starting screen.