Live Chat Help

Small Indoor Plug-In Siren

Follow

This article contains instructions for programming the Small Indoor Plug-In Siren with the Total Security main panel.

NOTE: If you purchased the siren as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a siren separately, and are now adding it to an existing system.

Programming the Small Indoor Plug-In Siren to a Total Security System:

  1. On the main panel, navigate to Main Menu -> Sensors -> Wireless Siren.
  2. Toggle the "Wireless Siren" setting to "OFF" (or leave it in the "OFF" position), and press "OK".
  3. Back out to the starting screen.
  4. Make sure the system is disarmed. You may also wish to disconnect any other sirens already on the system.
  5. Plug the siren into the wall power
  6. On the siren, press the black coding button. The lights on the siren will turn on and stay on.
  7. On the main panel, navigate to Main Menu -> Sensors -> Wireless Siren.
  8. Toggle the "Wireless Siren" setting to "ON", and press "OK".
  9. Your siren will beep once, then pause, then beep 4 times. The lights on the siren will stay on.
  10. Unplug the siren, and leave it unplugged for 5 seconds.
  11. Plug the siren back in. The siren will beep once.
  12. Test the alarm (press the panic button on a key fob, or arm the system and trigger a sensor). The siren is now programmed, and will sound when the alarm is triggered.
  13. If you disconnected any other sirens at the beginning, reconnect them now.
Have more questions? Submit a request

Comments

Powered by Zendesk