Live Chat Help

Water Level Sensor

Follow

This article contains instructions for programming a Water Level Sensor with the GSM system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

Programming Water Level Sensor with GSM main panel:

  1. Turn off any motion detectors to avoid accidentally programming them.
  2. On the Main Panel, enter your 6-digit SET password, then press Enter.
  3. Scroll to the right (using the '6' key) to select Zone, and press Enter.
  4. Select an appropriate Zone for the sensor. By default, Zone 9 is used for Water Level Sensors.
  5. With 'Coding' selected, press Enter.
  6. Trigger the sensor by pushing on its float.
  7. On the Main Panel, a string of zeros will be replaced by another string of numbers. Press Enter.
  8. Return to the main screen using the ESC key.
  9. Turn on any motion detectors that may have been turned off.
Have more questions? Submit a request

Comments

Powered by Zendesk