Live Chat Help

Vibration Sensor

Follow

This article contains instructions for programming a Vibration Sensor with the Total Security system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

Programming a Vibration Sensor with the Total Security Main Panel:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. On the Main Panel, enter your Administrator password, then press the Menu button [three horizontal lines].
  3. Navigate to "Sensors", then select "Sensor".
  4. Scroll to the desired Zone, and press OK. You will hear "Zone # - Add."
  5. Trigger the sensor by tapping on it. You will hear "Add - successfully programmed."
  6. Return to the starting screen using the Back button.
  7. Turn on any motion detectors that may have been turned off.
Have more questions? Submit a request

Comments

Powered by Zendesk