Live Chat Help

Vibration Sensor


This article contains instructions for programming a Vibration Sensor with the GSM system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

Programming Vibration Sensor with GSM main panel:

  1. Turn off any motion detectors to avoid accidentally programming them.
  2. On the Main Panel, enter your 6-digit SET password, then press Enter.
  3. Scroll to the right (using the '6' key) to select Zone, and press Enter.
  4. Select an appropriate Zone for the sensor. By default, Zone 8 is used for Vibration Sensors.
  5. With 'Coding' selected, press Enter.
  6. Trigger the sensor by tapping on it.
  7. On the Main Panel, a string of zeros will be replaced by another string of numbers. Press Enter.
  8. Return to the main screen using the ESC key.
  9. Turn on any motion detectors that may have been turned off.
Have more questions? Submit a request


Powered by Zendesk