Live Chat Help

Glass Break Sensor

Follow

This article contains instructions for programming a Glass Break Sensor with the Total Security system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

Programming a Glass Break Sensor with the Total Security Main Panel:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. Plug the Glass Break Sensor into the wall power.
  3. On the Main Panel, enter your Administrator password, then press the Menu button [three horizontal lines].
  4. Navigate to "Sensors", then select "Sensor".
  5. Scroll to the desired Zone, and press OK. You will hear "Zone # - Add."
  6. Trigger the sensor by tapping on it. You will hear "Add - successfully programmed."
  7. Return to the starting screen using the Back button.
  8. Turn on any motion detectors that may have been turned off.
Have more questions? Submit a request

Comments

Powered by Zendesk