Live Chat Help

Glass Break Sensor

Follow

This article contains instructions for programming a Glass Break Sensor with the S02 system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

Programming Glass Break Sensor with S02 main panel:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. Plug the Glass Break Sensor into the wall power.
  3. On the Main Panel, enter the following:
    <your 4-digit password> #
    7 # <2-digit zone number> #
  4. Trigger the sensor by tapping on it. Your panel will beep twice.
  5. On the Main Panel, press Return.
  6. Turn on any motion detectors that were turned off.
Have more questions? Submit a request

Comments

Powered by Zendesk