Live Chat Help

Gas Leak Detector

Follow

This article contains instructions for programming a Gas Leak Detector with the S02 system.

NOTE: If you purchased the detector as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a detector separately, and are now adding it to an existing system.

Programming Gas Leak Detector with S02 main panel:

Before beginning, decide on a Zone # to add the Gas Leak Detector to. This should be a zone between 01 and 08, as only those zones can be set to 'Emergency' mode for the Gas Leak Detector to work correctly. We recommend programming the Gas Leak Detector on an empty zone by itself.

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. On the Main Panel, enter the following:
    <your 4-digit password> #
    7 # <2-digit zone number> #
  3. Press the Test button on the Gas Leak Detector. Your panel will beep twice.
  4. On the Main Panel, press Return. Then, to set the Zone to 'Emergency,' enter the following:
    <your 4-digit password> #
    * <2-digit zone number>
    2 3 #
    Return
  5. Turn on any motion detectors that were turned off.

 

Have more questions? Submit a request

Comments

Powered by Zendesk