Live Chat Help

Door / Window Contact Sensor

Follow

This article contains instructions for programming a Door / Window Contact Sensor with the S02 system.

NOTE: If you purchased the sensor as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a sensor separately, and are now adding it to an existing system.

 

Programming a Door/Window Contact Sensor with the S02 Main Panel:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. On the Main Panel, enter the following:
    <your 4-digit password> #
    7 # <2-digit zone number> #
  3. Trigger the sensor by moving it away from the magnet. The light on the sensor will come on, and your panel will beep twice.
  4. On the Main Panel, press Return.
  5. Turn on any motion detectors that were turned off.

It's also a good idea to make sure that the Zone's attributes for the sensor are set to Zone Type 1 ('Immediate'). To set a Zone to Zone Type 1, do the following:

  1. On the Main Panel, enter the following:
    <your 4-digit password> #
    * <2-digit zone number>
    2 1 #
    Return
Have more questions? Submit a request

Comments

Powered by Zendesk